Volkswagen VW Caddy 2K ABS Pump Brae Control Unit Module 7E0614517L

Volkswagen VW Caddy 2K ABS Pump Brae Control Unit Module is a specialized component from the ABS and ESP system group, designed for precise control of brake system pressure and vehicle stability. This solution is dedicated to users expecting a proven, functional part for VW Group vehicles, offered in a configuration consistent with the requirements of the Mercedes brand.

Specifications and technical data

• SKU: 7E0614517L
• Mark: Mercedes (Genuine OE)
• Condition: Used
• OEM Part Number: 7E0614517L
• Substitutable numbers: 7E0614517L, 7E0 614 517 L
• Part type: ABS/Stability Control Hydraulic Unit
• Category: ABS & Stability Hydraulic Units

Function and application in the ABS and ESP system

The described pump with control unit is responsible for precise brake pressure modulation and cooperation with the vehicle's stability control system. In practice, this means:

• active control over wheel locking during emergency braking,
• cooperation with wheel speed and system pressure sensors,
• coordination of brake operation with the electronic stability program,
• increased predictability of vehicle behavior on slippery surfaces.

Thanks to the integrated brake control unit, this component serves as the central executive module for the entire ABS/ESP system, influencing the safety and consistency of vehicle reactions in emergency situations.

Benefits of using an original module

Choosing this ABS pump with control unit is a solution for users who expect:

• compatibility with the vehicle's factory electrical architecture,
• stable cooperation with the existing sensor installation and brake lines,
• preservation of factory operating parameters for driver assistance systems,
• possibility of computer diagnostics in accordance with manufacturer procedures.

The component from the ABS and ESP system group allows for restoring proper system operation after a failure of the previous module, without the need for vehicle construction modifications.

Product characteristics and installation

The ABS pump with brake control unit is offered as a part removed from a vehicle, in used condition, which allows for economical repair while maintaining an appropriate quality level. The module is prepared for installation in place of the factory equivalent, maintaining original mounting points as well as hydraulic and electrical connections.

During installation, it is recommended to:

• perform installation by a qualified service center with experience in working with ABS/ESP systems,
• bleed the brake system in accordance with the manufacturer's procedure,
• perform adaptation and error clearing using an appropriate diagnostic tester,
• verify system tightness and the correctness of the control unit's communication with the vehicle network.

Mercedes ABS and ESP system – expansion and selection of components

If you are planning a comprehensive repair or upgrade of the braking zone in your Mercedes and need other components from the same group, such as pumps, control modules, or control valves, check the available parts in the Mercedes ABS and ESP system category.

Practical knowledge about used components

When selecting a used ABS module, it is worth knowing good practices related to technical condition inspection, diagnostics, and the cost-effectiveness of repairs compared to purchasing new parts. A broader perspective on the use of second-hand components in VAG group cars can be found in the article Audi on second-hand parts – tuning and repairs without loss of quality, which discusses, among other things, the economic and technical aspects of such solutions.