Audi A4 B8 A5 8T Brake Pump ABS Module Hydraulic Control Braking 8K0907379CG

Audi A4 B8 A5 8T Brake Pump ABS Module Hydraulic Control Braking is a component from the ABS and ESP system group, designed to operate within the advanced electronic stability control and traction control system in Audi vehicles. This OEM solution allows for the restoration of proper anti-lock braking system functionality and its associated safety features, while maintaining the vehicle's factory operating parameters.

Specifications and technical data

• SKU: 8K0907379CG
• Mark: Audi
• Condition: Used
• OEM Part Number: 8K0907379CG
• Substitutable numbers: 8K0907379CG, 8K0 907 379 CG
• Category: ABS & Stability Hydraulic Units

Purpose and function in the vehicle

Audi A4 B8 A5 8T Brake Pump ABS Module Hydraulic Control Braking works with the electronic braking system control, responsible for precise pressure distribution in the brake circuits during emergency braking and in situations of traction loss. This component is an integral part of the system responsible for:

• preventing wheel lock-up during braking (ABS),
• cooperation with the electronic stability program (ESP),
• traction control during acceleration and on slippery surfaces,
• maintaining predictable, repeatable vehicle behavior in emergency situations.

By using an original solution from the ABS and ESP system group, compatibility with the car's factory electronic and hydraulic architecture is maintained.

Benefits of using an original component

Using an ABS pump sourced from Audi allows for maintaining the consistency of the entire braking system with the vehicle's software and factory configuration. Key advantages include:

• Full integration with vehicle electronics – proper cooperation with wheel speed sensors, the ESP module, and other controllers.
• Stable braking system performance – predictable ABS operation in various road conditions.
• Reduction of the risk of diagnostic errors and fault messages on the dashboard.
• Possibility of proper adaptation and diagnostics using professional service testers.

Installation and operational characteristics

The pump is designed for installation in Audi A4 B8 and A5 8T series vehicles equipped with an ABS system integrated with electronic stability control. The OEM design allows for:

• maintaining the original routing of brake lines and electrical harnesses,
• reproducing the factory mounting method in the engine bay,
• proper bleeding and activation of the system after installation.

The component comes from the used parts group, which allows for economical repair while maintaining the manufacturer's original specifications.

Part selection and technical aspects

When selecting an ABS pump for a specific Audi A4 B8 or A5 8T, it is crucial to verify compatibility with the vehicle's configuration based on catalog data, the VIN, and manufacturer markings. Proper selection ensures:

• compatibility with the equipment version and applied assistance systems,
• correct communication with the vehicle's controller network,
• trouble-free adaptation after installation.

For users and workshops looking to deepen their knowledge of diagnostics and the selection of complex vehicle system components, the blog article Fuel system – injectors, pumps, and fuel tank: maintenance and regeneration, which discusses, among other things, the principles of identifying parts by OEM numbers and good operational practices, may be helpful.

Expansion and service of the Audi braking zone

If you are planning a comprehensive repair or upgrade of the braking zone in your Audi and need other components from the same group, such as control modules, wheel speed sensors, or pressure lines, check the available parts in the Audi ABS and ESP system category.