Mercedes C238 4Matic M256 Automatic Transmission Transfer Rear Axle Propshaft

Mercedes C238 4Matic M256 Automatic Transmission Transfer Rear Axle Propshaft is a precisely engineered drivetrain component, dedicated to models with all-wheel drive and an automatic transmission. As an original Mercedes component, it ensures drivetrain consistency, stable torque transfer, and predictable vehicle behavior under various loads. This is a solution for users who expect a technically matched part with a proven design.

Specifications and technical data

• SKU: A2384103702
• Mark: Mercedes (Genuine OE)
• Condition: Used
• OEM Part Number: A2384103702
• Substitutable numbers: A2384103702, A 238 410 37 02
• Location on the vehicle: Rear
• Fuel type: Petrol
• Gearbox type: Automatic
• Category: Additional Propshaft Parts

Purpose and drivetrain compatibility

The presented propshaft has been designed for the rear section of the drivetrain in Mercedes C238 series vehicles equipped with 4Matic drive and an automatic transmission. Its task is to provide a stable connection between the transmission and the rear drive unit, while maintaining proper geometry and joint operation throughout the entire suspension travel range.

Selecting the correct propshaft is crucial for:

• reducing vibration and noise in the cabin,
• even torque distribution to the rear axle,
• maintaining the correct operation of the 4Matic system in automatic drive distribution modes.

Technical characteristics and 4Matic drive compatibility

The shaft is adapted for use in vehicles with a gasoline engine and an automatic transmission, which means it is adjusted to the specific dynamic loads generated by such a powertrain. The design accounts for operation with the 4Matic system, where axle torque distribution requires precise, repeatable force transfer without excessive play or response delays.

Thanks to appropriately selected joints and flexible damping elements, the shaft supports:

• smooth acceleration without jerking,
• stability at higher speeds,
• proper cooperation with traction control and electronic stability control systems.

Benefits of using an original Mercedes component

Using an original propshaft in a 4Matic system allows for maintaining factory vehicle handling parameters and component durability. Factory fitment minimizes the risk of improper installation, balancing issues, or premature wear of bearings and joints in other drivetrain components.

Key advantages include:

• consistency with the suspension and rear axle design,
• maintenance of the manufacturer's specified operating clearances,
• reduction of the need for additional modifications during installation.

Part condition and service application

The offered propshaft is a used component, which makes it an attractive cost-effective alternative while maintaining the manufacturer's original specifications. It is suitable both for standard replacement of a worn shaft and for drivetrain repairs following mechanical damage, where restoring the correct geometry and operation of the rear drive section is critical.

It is always recommended to verify compatibility with the specific engine version and transmission before selecting the component to fully utilize the benefits of the original design and avoid compatibility issues.

If you are planning a comprehensive repair or upgrade of the drivetrain area in your Mercedes and need other elements from the same group, such as intermediate shafts, flexible joints, or shaft supports, check the available parts in the Other Mercedes Cardan joint parts category.

Technical support and additional information

When selecting a propshaft for a specific vehicle configuration, it is helpful to compare catalog data and manufacturer markings to ensure full compatibility with the drivetrain. In case of doubt, it is worth consulting a mechanic or technical department, especially with all-wheel-drive vehicles, where precise fitment has a direct impact on the durability of the entire system.

For users interested in a broader context of selecting original components and the impact of design on vehicle character, an article discussing the differences between classic and modern automotive solutions may be helpful – more information can be found in the material Classic Mini vs modern MINI – how the design has changed and which original Mini parts help preserve their character.

If you want to reduce your car's downtime in the workshop and optimally plan repairs using professional used parts, it is also worth checking out the guide how a wide assortment in one warehouse actually shortens your car's downtime at the mechanic, which shows a practical approach to service logistics.