BMW 3 Series E90 E91 E92 335i N54 Manual Drive Shaft Propshaft 7558494

BMW 3 Series E90 E91 E92 335i N54 Manual Drive Shaft Propshaft is an original drivetrain component designed for installation in the rear section of the vehicle. By being tailored for the manual transmission version, it ensures proper integration with the factory drivetrain and stable torque transmission. This used component from the Cardan Joints category allows for technical repairs without interfering with the vehicle's original construction.

Specifications and technical data

• SKU: 7614384
• Mark: BMW (Genuine OE)
• Condition: Used
• OEM Part Number: 7614384
• Substitutable numbers: 26107614384, 7614384, 26107558494, 7558494
• Weight: 150
• Location on the vehicle: Rear
• Gearbox type: Manual
• Category: Propshafts

Purpose and function of the drive shaft

The presented drive shaft is a component of the rear drivetrain section, responsible for transferring torque from the transmission to the rear differential. The design, adapted for the N54 engine and E90/E92 series bodies, ensures correct geometry, proper interaction with Cardan joints, and adequate vibration damping under typical operating conditions.

Thanks to its dedication to the manual transmission, the correct operating characteristics are maintained during load changes, which translates into predictable drivetrain behavior, reduction of unwanted play, and stability during dynamic acceleration.

Benefits of using an original drive shaft

Using an original drive shaft in a BMW 3 Series with an N54 engine allows for maintaining the factory performance parameters of the drivetrain. The component has been designed for specific loads and torque characteristics, which promotes even power transmission and reduces vibrations in the cabin.

The most important advantages include:

• maintaining proper alignment between the transmission and the rear differential,
• correct interaction with Cardan joints and mounting elements,
• appropriately selected mass and stiffness, influencing the drivetrain's operating refinement,
• possibility of installation without structural modifications in dedicated models.

Condition, installation, and technical aspects

The drive shaft is a used component, which in practice means the possibility of an economical repair while maintaining the original construction. The product comes from the BMW brand, ensuring that factory mounting points and compatibility with standard suspension and drivetrain elements are preserved.

Its placement in the rear of the vehicle requires precise installation, maintaining the correct alignment relative to the manual transmission and the rear differential. A correctly selected drive shaft reduces the risk of torsional vibrations, noise, and accelerated wear of joints and support bearings.

Application in drivetrain service and repairs

This drive shaft model is suitable for replacing a damaged component after a mechanical failure, in cases of excessive play in the drivetrain, or after modifications that required restoring the factory configuration. Choosing an original component is particularly important in higher-power vehicles, where the drivetrain operates under greater load.

A properly selected drive shaft helps to:

• restore proper drivetrain refinement,
• reduce knocking and vibrations during starting and gear changes,
• maintain vehicle stability at higher speeds,
• limit the wear of cooperating drivetrain components.

If you are planning a comprehensive repair or upgrade of the drivetrain area in your BMW and need other elements from the same group, such as shafts, universal joints, or supports, check the available parts in the BMW Cardan Joints category.

If you are considering using used components for a wider vehicle repair and want to better understand the differences between used parts and aftermarket body panels, the article Post-accident repair of your car: why are used body parts a better choice than aftermarket replacements? may be helpful, as it compares both solutions from a technical and economic perspective.